Friday, May 2, 2008 - New servers are in! Click-in for more info!
VoyForums

Sun, July 20 2008, 01:27 [ VoyUser Login optional ] [ Contact Forum Admin ] [ Main index ] [ Post a new message ] [ Search | Check update time | Archives: 1, 2, 3, 4, [5], 6, 7 ]

[ Next Thread | Previous Thread | Next Message | Previous Message ]

Date Posted: - Wednesday - 03/ 2/05 - 2:15pm
Author: Wes
Author Host/IP: vailmax2-7.vail.net / 65.38.130.135
Subject: A quick measurement anyone??

Could anyone measure the L shaped counter top where the lid for the fridge goes (no need for lid measurement)? A Mariner 31/32 counter will work. 6 measurements total:

-Back under old electric panel
-edge under the sliding cupboards
-edge along the sink
-edge along the stove area
-forward edge
-edge above the drawers

My boat is a 1000+ miles away and I am trying to precut some thin gauge marine kitchen type stainless for a counter top.
Thanks for any help
Wes

[ Next Thread | Previous Thread | Next Message | Previous Message ]

Replies:

[> Re: A quick measurement anyone?? -- John Bye, - Thursday - 04/ 7/05 - 8:59pm (lsanca1-ar3-4-47-030-110.lsanca1.elnk.dsl.genuity.net/4.47.30.110)

I finally got down to the boat. I don't know if you still need these measurements but here they are. Hope it helps.
I measured to the inside edge of the molding strip in all cases. The molding is 1/2 inch wide and it goes all the way around.
backside = 25 inches
next to sink = 17 3/8 inches
port side = 30 1/8 inches
stove side = 14 inches

This is off my M32, You can deduce the other two measurements (front side = 25 - 14 (11 inches)
starboard short side = 30 1/8 - 17 3/8 (12 6/8 inches)
You may need to add an inch (2 molding widths) depending on what you are doing.

[Edit]

[ Contact Forum Admin ]

Forum timezone: GMT-5
VF Version: 2.94, ConfDB:
Before posting please read our privacy policy.
VoyForums(tm) is a Free Service from Voyager Info-Systems.
Copyright © 1998-2008 Voyager Info-Systems. All Rights Reserved.