VoyForums

[ VoyUser Login optional ] [ Main index ] [ Post a new message ] [ Search | Check update time | Archives: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10 ]

[ Next Thread | Previous Thread | Next Message | Previous Message ]

Date Posted: Fri March 23, 2012 11:16:23AM
Author: Dave in NC
Subject: Re: swing arm
In reply to: Paul D. NY 's message, "Re: swing arm" on Tue March 20, 2012 8:32:32PM

Paul, if you are comfortable removing the rear wheel, then you are almost there. Unbolt rear bevel gear and shocks. Then the caps on both sides of the frame and remove swing arm. There is a pin holding the front splinded shaft of the drive shaft to the output shaft on the engine. Use paper clip to push into hole to release pin. Careful it will fly across the room and you will spend hours looking for it. On re-assembly, there is a specific torque sequence for the swing arm bearings. Did mine a few years ago, just to clean and lube. Relatively easy job, just make room for a large pile of parts. I have some pictures some where when I did mine.

Dave

[ Next Thread | Previous Thread | Next Message | Previous Message ]
[ VoyUser Login ] Not required to post.
Post a public reply to this message | Go post a new public message
 * HTML allowed in marked fields.
Message subject (required):

Name (required):

  E-mail address (optional):

* Type your message here:


Notice: Copies of your message may remain on this and other systems on internet. Please be respectful.
 The Voy.com User Agreement applies to all visitors.

Forum timezone: GMT-6
VF Version: 2.94, ConfDB:
Before posting please read our privacy policy.
VoyForums(tm) is a Free Service from Voyager Info-Systems.
Copyright © 1998-2012 Voyager Info-Systems. All Rights Reserved.