Name (required):

  Expression ^{(Optional mood/title along with your name) Examples: (happy, sad, The Joyful, etc.) help)}

  E-mail address (required):

* Type your message here:
>>I have a ski doo elan 250 deluxe, My paper work say 74 >>but according to the pictures on your page here it >>looks like that 78. >> My question is the single carb, its a tillotson, says >>oh10, it has a turn screw on the left side as you face >>forward with a L by it and a bolt head also on the >>left side that has a H by it, where should they be >>set? I would love a repair manual for this sled, >>clutch setting and maintenaince ect.. any help would >>be appriciated. >> Thanks Mike Q >Mike, those letters you saw designate h for high and l >for low. Those are your jet screws. you should not >have to adjust the high speed jet as it is pre-set at >the factory and you could end up melting your pistons >if set to high. The low speed jet however, can be >adjusted. To do this, first turn the low speed jet >screw all the way in and back out the screw between >1-1/4 and 1-1/2 turns. You will know when it is set >properly by a simple test under load. A sudden burst >of throttle and the motor boggs down like its ready to >stall means that you have it set to lean. Remember a >little is good does not mean a lot is better.

Notice: Copies of your message may remain on this and other systems on internet. Please be respectful.