4) SUNSHIELD & BODY PANELS
Front side panels outside the downtubes must be flat and can not extend above the top of the
downtube. They also may not extend above the highest point of the hood or obstruct the drivers
view.
Lower sidepanels may run turn outs not to exceed 1 inch from bend.
Rear Sailpanels may run a turn out not to exceed 2.5 inches from the bend and the bend can be
no farther back than the rear of the rear cage down tube. The rear down tube can not be
exaggerated to gain sailpanel area.
Front sunshield not to exceed 6 inches. No whicker bills.
New Rule
4) SUNSHIELD & BODY PANELS
Front side panels must be flat and can not extend above the top of the
downtube. They also may not extend above the highest point of the hood or obstruct the drivers
view.
Lower sidepanels may run turn outs not to exceed 1 inch from bend.
Rear Sailpanels may run a turn out not to exceed 2.5 inches from the bend and the bend can be
no farther back than the rear of the rear cage down tube. The rear down tube can not be
exaggerated to gain sailpanel area.
Front sunshield not to exceed 6 inches. No whicker bills.
[
Next Thread |
Previous Thread |
Next Message |
Previous Message
]
