VoyForums
[ Show ]
Support VoyForums
[ Shrink ]
VoyForums Announcement: Programming and providing support for this service has been a labor of love since 1997. We are one of the few services online who values our users' privacy, and have never sold your information. We have even fought hard to defend your privacy in legal cases; however, we've done it with almost no financial support -- paying out of pocket to continue providing the service. Due to the issues imposed on us by advertisers, we also stopped hosting most ads on the forums many years ago. We hope you appreciate our efforts.

Show your support by donating any amount. (Note: We are still technically a for-profit company, so your contribution is not tax-deductible.) PayPal Acct: Feedback:

Donate to VoyForums (PayPal):

Login ] [ Contact Forum Admin ] [ Main index ] [ Post a new message ] [ Search | Check update time | Archives: 1[2]34 ]
Subject: Sailer 23 General Advice


Author:
Ariel of Pool
[ Next Thread | Previous Thread | Next Message | Previous Message ]
Date Posted: 23:10:47 10/02/2008 Sun

Hi all,

We recently bought a lifting keel Sailer 23 and have her out of the water at the minute and I was hoping for some general advice.

Apart from the obvious antifouling job, the other problem that we are trying to address is that we noticed very slight drips of water coming in through transom from the lower rudder pintle bolt holes. Out the water we can see that the seal around the pintle is worn. Our plan is to remove the bolted fitting and replace the seal with suitable epoxy/waterproofing. Any advice from someone who has done this job would be appreciated.

On a wider issue, I think that this weakening has been caused because there is some play in the rudder. This is being caused because the hole in this lower pintle (which the metal rudder post goes through) seems to have widened - which means the rudder 'thunks' around. Am I worrying about nothing or should I be looking to get a replacement lower pintle / bracket? Any advice would be appreciated.

The other question I had was about scarificial anodes. The one we have under the hull (connected to the prop shaft) seems to have been doing its job and needs to be replaced. I was wondering, though, whether there should be some sort of anode on the keel?

Thanks,

Rav.

[ Next Thread | Previous Thread | Next Message | Previous Message ]

Replies:
Subject Author Date
Re: Sailer 23 General AdviceIan11:41:52 13/02/2008 Wed
Re: Sailer 23 General AdviceIan11:45:04 13/02/2008 Wed
Re: Sailer 23 General AdviceIan11:50:22 13/02/2008 Wed
Re: Sailer 23 General AdviceColin Vinson22:24:19 13/02/2008 Wed


[ Contact Forum Admin ]


Forum timezone: GMT+0
VF Version: 3.00b, ConfDB:
Before posting please read our privacy policy.
VoyForums(tm) is a Free Service from Voyager Info-Systems.
Copyright © 1998-2019 Voyager Info-Systems. All Rights Reserved.