| Subject: Re: IGT S+ Coin Comparator Harness |
Author:
Jay
| [ Next Thread |
Previous Thread |
Next Message |
Previous Message
]
Date Posted: 21:46:17 09/04/06 Mon
In reply to:
Bob
's message, "IGT S+ Coin Comparator Harness" on 18:32:14 09/02/06 Sat
The person you want to speak to is April.
937-672-9053 a69lemans@woh.rr.com
There is basically two different harneses. One is for large denomination (ie $5.00 tokem, silver dollar). The other is for small denomination. I have never heard them referred to as loop...
I believe you can get the tool for pin extraction at Jameco
www.jameco.com shame to buy this if this is for a 1 time job. If you are careful you can push it straight out using a set of needle nose. After the solder job simply put it back in place and then pull it back until it locks.
> I need a new S+ Comparator Harness for a Haywire
>Deluxe; The one I took out (bad) has 3 wires and a red
>wire loop on it- the 3 wires are black, yellow & red.-
>and then there is the red wire loop in addition. I
>found a supplier but they list 2 and I don't know
>which one to order- 1 is a Multi-line for CC-16 and
>the other "Loop for CC-16". Does anyone know which one
>would match the one I took out? They show no picture
>or diagram. Also- does anyone know how to remove a
>pin from the Comparator end so I can solder back the
>broken wire? Thanks!
[
Next Thread |
Previous Thread |
Next Message |
Previous Message
] |
|
