VoyForums
[ Show ]
Support VoyForums
[ Shrink ]
VoyForums Announcement: Programming and providing support for this service has been a labor of love since 1997. We are one of the few services online who values our users' privacy, and have never sold your information. We have even fought hard to defend your privacy in legal cases; however, we've done it with almost no financial support -- paying out of pocket to continue providing the service. Due to the issues imposed on us by advertisers, we also stopped hosting most ads on the forums many years ago. We hope you appreciate our efforts.

Show your support by donating any amount. (Note: We are still technically a for-profit company, so your contribution is not tax-deductible.) PayPal Acct: Feedback:

Donate to VoyForums (PayPal):

Sat, August 08 2020, 23:00Login ] [ Contact Forum Admin ] [ Main index ] [ Post a new message ] [ Search | Check update time | Archives: 1234[5]678910 ]


[ Next Thread | Previous Thread | Next Message | Previous Message ]

Date Posted: - Wednesday - 03/18/09 - 9:06pm
Author: Randall
Subject: ring nails
In reply to: Steve M-32 SEAN O'Sea 's message, "Ring nails" on - Wednesday - 03/18/09 - 8:10pm

The only other place I've encountered ring nails was at the base of the aft cabin bulkhead. See my "blog" on that project for pictures and remarks like Steve's: @%$*&^%.

[ Next Thread | Previous Thread | Next Message | Previous Message ]


Replies:

[> [> [> [> [> [> [> Roof demo -- Dan M32 #36 Independence, - Thursday - 03/19/09 - 2:13am

Terry,
Well I had a little time yesterday so I attacked the roof. I only had about an hour but I got about half of it done. Here’s what I figured out-
After pulling up the glass which was very easy by pushing a flat bar (pry bar) under it and then pulling sections of it up, I tried driving the bar under the edges of the plywood and prying but it wasn’t coming. I took a skillsaw and set the depth at slightly less than the thickness of the plywood and cut as close as was comfortable on either side of the nails over the deck beam. They are stainless nails on my boat.

I also cut along the bottom. There are screws around the outside edges. Once cut it was easy to pull the sections of ply out, sometimes with a little persuasion from a hammer from the underside.

I tried prying off the remaining strips but was concerned about damaging the beams. I tried something else. Using a block of wood, I held it against the edge of the strip and smacked it with a hammer. The pieces between the nails came off easily leaving the protruding nails. The nails came out easily with a hammer or pry bar. I could actually reuse the nails if I go that route.
The deck beams do have a slight hollow in the top.
It was alot easier than I thought it would be.
I took some photos but can't figure out how to post them. Help anyone?
Dan


[ Edit | View ]





[ Contact Forum Admin ]


Forum timezone: GMT-5
VF Version: 3.00b, ConfDB:
Before posting please read our privacy policy.
VoyForums(tm) is a Free Service from Voyager Info-Systems.
Copyright © 1998-2019 Voyager Info-Systems. All Rights Reserved.