Re: 63 chevyll -- Lemons Header Message Board

[ Show ]

Support VoyForums

[ Shrink ]

VoyForums Announcement: Programming and providing support for this service has been a labor of love since 1997. We are one of the few services online who values our users' privacy, and have never sold your information. We have even fought hard to defend your privacy in legal cases; however, we've done it with almost no financial support -- paying out of pocket to continue providing the service. Due to the issues imposed on us by advertisers, we also stopped hosting most ads on the forums many years ago. We hope you appreciate our efforts.

Show your support by donating any amount. (Note: We are still technically a for-profit company, so your contribution is not tax-deductible.) PayPal Acct: Feedback:

Donate to VoyForums (PayPal):

[ Login ] [ Contact Forum Admin ] [ Main index ] [ Post a new message ] [ Search | Check update time | Archives: [1] ]

Subject: Re: 63 chevyll

Author:
Dan Lemons

[ Next Thread | Previous Thread | Next Message | Previous Message ]

Date Posted: 07:43:28 01/04/02 Fri
In reply to: Derrick 's message, "63 chevyll" on 17:25:51 12/29/01 Sat

>I'm in the process of building a 63 chevyll w/stock
>chassis but w/hiedts weld on crossmember. The engine
>is a olds rocket block (dry sump) w/ canfield 220
>heads (no exh porting done, just polished) .640int
>.645exh 276int 284exh @.050 114 LS. 13.5:1 comp. Car
>weighs 3020lbs.
>Is it possible to make headers for this? and what size
>would the primaries be?

Hi Derrick, thanks for the e-mail. We have 2 headers that should work. One for the Heigt's front end is inside the frame, made for rack and pinion and side mounts, designed on a full heigt's front clip, but may not fit your dry sump lines on drivers side, the other is a fender well type made for the stock front end with collectors facing back under floor. This is a longer tube header, about 38", but ez install, etc.
As far as tube size I would need info on HP, cubic inches, 10' tire or big tire, trans type and stall setting, will you use nitrous? etc. Thanks again, Dan Lemons.

[ Next Thread | Previous Thread | Next Message | Previous Message ]