| Subject: Re: Mustang Headers, Fox |
Author:
dan lemons
|
[
Next Thread |
Previous Thread |
Next Message |
Previous Message
]
Date Posted: 07:26:43 03/16/02 Sat
In reply to:
Greg Downs
's message, "Re: Mustang Headers, Fox" on 21:23:52 03/15/02 Fri
>>>Dan, I am building a 92 Mustang, I am going to put a
>>>420 ci, small block mopar in it, It has W-2 heads,
>>>Havnt ran it on dyno yet, but should be around 600HP
>>>without nitrous, Do you think it would be posible to
>>>change the flanges on your SB chevy mustang headers
>to
>>>fit the mopar engine?
>>
>>Hi Greg, thanks for the e-mail. Boy, thats a tuff one!
>>We could send you our tubes for the SB Chev header and
>>collectors, but you would have to fit them to your
>>flanges, which would take a little time but should
>>work fine. Our header was designed with an Anthony
>>Jones K member in the car, so you would have to have
>>one for the tubes to fit.
>>Thanks again, Dan Lemons.
>
> Thanks Dan, what would it cost for the tubes an
>collectors, would the collectors be slip on or would
>they have to be welded on, thanks, Greg
Hi Greg, for our slip on merged type collectors with the transition cone in them, tabs, bolts, etc. plus the tubes fabricated and TIG welded in any size you need, stepped or not, and EVAC tubes if you need them, would be $557 plus shipping. Thanks again, Dan.
[
Next Thread |
Previous Thread |
Next Message |
Previous Message
]
| |
Feedback: 