Re: Pictures of your '67 Chevelle BBC Headers -- Lemons Header Message Board

[ Show ]

Support VoyForums

[ Shrink ]

VoyForums Announcement: Programming and providing support for this service has been a labor of love since 1997. We are one of the few services online who values our users' privacy, and have never sold your information. We have even fought hard to defend your privacy in legal cases; however, we've done it with almost no financial support -- paying out of pocket to continue providing the service. Due to the issues imposed on us by advertisers, we also stopped hosting most ads on the forums many years ago. We hope you appreciate our efforts.

Show your support by donating any amount. (Note: We are still technically a for-profit company, so your contribution is not tax-deductible.) PayPal Acct: Feedback:

Donate to VoyForums (PayPal):

[ Login ] [ Contact Forum Admin ] [ Main index ] [ Post a new message ] [ Search | Check update time | Archives: [1] ]

Subject: Re: Pictures of your '67 Chevelle BBC Headers

Author:
Dan Lemons

[ Next Thread | Previous Thread | Next Message | Previous Message ]

Date Posted: 07:24:24 08/07/01 Tue
In reply to: BOBBY MATTINGLY 's message, "Pictures of your '67 Chevelle BBC Headers" on 19:04:00 08/03/01 Fri

>WHEN DO YOU THINK YOU WILL HAVE THE PICS FOR THIS
>HEADER UP?GETTING CLOSER TO ORDERING.I HAVE BEEN TEST
>FITTING THE ENGINE AND TRANS WITH AN UNKNOWN BRAND OF
>USED HEADERS THAT FIT OK EXCEPT FOR #3 IS A SLIP TUBE
>THAT HITS THE TOP OF THE #7 PORT (WON'T BOLT UP) AS IT
>GOES UP AND OVER, DOWN ALONG THE FIRE WALL.(BOY, ARE
>THESE HEADERS A BI**H!)I AM WAITING TO WELD THE MOTOR
>AND MID PLATES, TRANS X-MEMBER AND STEERING
>COLUMN.SHOULD I CONTINUE TO BASE ALL POSITIONS ON YOUR
>HEADERS? ('67 PONTIAC GTO, BBC W/BRODIX HEADS,STUDS,JW
>ULTRA-GLIDE TRANS,CSI STARTER)
Hi Bobby, thanks for the e-mail. The shop is jammed with work right now and I'm not sure when we can get our donor car in for photo's for the web site. We have pic's from our design headers, their not pretty but I can try to e-mail them to you if it will help. The design car was origional BB with BB motor mount frame stands. These position engine about 1/2" lower than SB frame stands. Your Steering column will be fine in stock position. Rear trans mount is very low and will be in the way if you are going to run exhaust system. We will have available this winter a chrome moly replacement X member with much more room. Thanks again, Dan

[ Next Thread | Previous Thread | Next Message | Previous Message ]

Replies:

Subject	Author	Date
Re: Pictures of your '67 Chevelle BBC Headers	BOBBY MATTINGLY	21:21:40 08/07/01 Tue