| Subject: Re: 565 Big Chief headers f/ 69 Camaro |
Author:
dan lemons
|
[
Next Thread |
Previous Thread |
Next Message |
Previous Message
]
Date Posted: 07:02:40 10/15/02 Tue
In reply to:
Andy Vandevelde
's message, "565 Big Chief headers f/ 69 Camaro" on 10:38:16 10/14/02 Mon
>Dan,
> I would like to purchase a set of headers to install
>my new engine in my car. I did not see an application
>form anywhere on your site, so I need to know what all
>info you need for construction of the headers. The
>car is typical of the outlaw 10.5 street cars of the
>osca. It is a 3400lb 69 camaro (race ready with me in
>it) with factory steering box and linkage. It has
>factory A-plates as well. The trans is a turbo 400
>w/trans brake, but I will soon switch to a glide combo
>w/1.72 first gear. The 8" converter stalls around
>5600 RPM. Rear gears vary between 4:56 and 4:11. I
>use a flowmaster exhaust system that extends all the
>way to the back axle. I will be making up a new
>exhaust/muffler system to match the new headers and am
>open for any advice you may have when building it.
>The engine is a 565 with Dart Big Chief 18* heads and
>9.8 deck bowtie block. It will use a single 1250
>Dominator and a plate nitrous system. Compression is
>quite high for a nitrous motor so I will be limiting
>shots to 250 HP or less. Does the $850.00 cover
>shipping and taxes, etc... Please let me know any
>additional info you need and we can get the ball
>rolling on this.
>Thanks
>Andy
Hi Andy, thanks for the e-mail. From your information, plus depending on your HP on motor, you should need a 2 3/8" header with a 4 1/2" collector. We designed this header with the engine setting on small block front motor mounts, this is an important issue as there is not much room. I can give you more info about this if you call. Sales tax only applies if the sale is in California and shipping would be in addition to the cost of the header.
Thanks again, Dan Lemons.
[
Next Thread |
Previous Thread |
Next Message |
Previous Message
]
| |
