| Subject: complete ASCS sprint car operation |
Author:
Jeff Bell
|
[
Next Thread |
Previous Thread |
Next Message |
Previous Message
]
Date Posted: 15:38:44 02/13/12 Mon
Getting out of racing and selling complete ASCS operation, would prefer to sell as a package deal but, will sell seperate also?
360 ASCS ENGINE
5 races on engine since built in March of 2011
ASCS heads purchased from Wesmar with legal port work, titanium valves, retainers & Tool Room springs
T&D shaft rockers
JE pistons
Scat lightweight crank & rods
Erson cam
lightened Bow Tie block
MPD U-Joint
Saldana valve covers
Dan Olson oil pan
Bromme oil tank
Hilborn Injection
Barnes 4 stage oil pump with filter mount
KSE water pump & front cover
Shaver Wesmar gear drive
Waterman fuel pump
Vertex magneto
R2C air filter with carbor fiber base, boots & outerwear
Schoenfeld 1 7/8" headers & mufflers with ceramic coating
fuel system & magneto set up by French Grimes Race Systems
2008 MAXIM 87-40 RAISED RAIL
Winters 4.11 rear end with thermo coating, titanium lower shaft, studs/bolts & all ti options. Ultra light long spline axle
Red Devil titanium inboard brake system
KSE Gen 2 steering gear & blue PS pump
ATL 28 gallon lightweight tank & bladder
Saldana radiator
Advanced shocks - RR & LR adjustable with all dyno & set up sheets
Dead On adjustable bird cages
2 1/2" lightweight front axle with Winters titanium snout spindles & hubs, Wilwood caliper & Brakeman rotor
Wilwood 7/8" master cylinder
Weld wheels - RR has OBL, LR has IBL, all beadlock & wheel center bolts are titanium
FBN top & front wing
Quick Car deluxe gauge panel
Tel Tac OTP
Kirkey full containment seat with all titanium hardware
Crow belts
car has all new paint & powder coat, 99% of the bolts on car are titanium, most all parts are either new or have 5 or less races
2008 CARGO MATE 24' TRAILER
upper & lower cabinets with work bench and closet
120 & 12 volt lighting
swing out rear halogen work lights
white aluminum walls
vinyl floor
diamond plate rear drop down door
2 - 4' tire racks
HRP 6 fuel jug rack
HRP 2 front end & 1 rear end rack
HRP radius rod rack
6 shock rack
nitrogen tank mount
tires are new load range E with a spare
HONDA RECON QUAD
electric start & reverse
set up with push bumper and tool box
SPARE PARTS
Winters 4.11 rear end with thermo coating, titanium lower shaft, studs/bolts & all ti options. Lightweight long spline axle
1 set axle nuts
Winters lightweight long spline rear axle
Wilwood inboard caliper
Red Devil titanium brake hub
DMI brake hub
Red Devil coated chromoly inboard rotor
Brakeman inboard rotor
MPD bird cage set
Winters torque tube (new)
complete set of radius rods & heims
2 1/2" lightweight front axle with Winters titanium snout spindles & hubs, Wilwood caliper, Brakeman rotor
2 - 2 1/2" lightweight bare front axles (new)
13 5/8" watts link
3 RR wheels with OBL, titanium beadlock & wheel center bolts
2 LR wheels with IBL, titanium beadlock & wheel center bolts
1 front rim shell
2 Advanced small body front shocks with dyno sheets
2 Advanced RR & LR cockpit adjustable gas shocks with dyno & set up sheets
rear wing tee
1 set rolling top wing posts
1 set front wing posts
Schoenfeld 1 7/8" headers (new in box)
1 set Spin Tech mufflers
ATL 28 gallon fuel tank
tons of decent tires, SCS gear sets, Kinsler jets with case, wheel spacers, heims, hose, fittings, etc., everything goes !
TOOLS
car stands
aluminum wheel wrench
beadbreaker
tire groover
tire siper
transponder with 120 volt & car charger
Kwik Change bleeder kit with pump & case
leak down tester
tire gauge
hood blanket
fuel tank cover
oil tank heater
fuel jugs
etc., etc., etc.
$29,000 for everything to go racing except my truck ! Have equipment for racing both winged & non wing. This is all very nice stuff, no junk & most everything is 5 races old or less ! Jeff Bell 425-231-5219
[
Next Thread |
Previous Thread |
Next Message |
Previous Message
]
| |
Feedback: 