VoyForums

[ VoyUser Login optional ] [ Main index ] [ Post a new message ] [ Search | Check update time | Archives: 1, 2, 3, 4, 5, 6, 7, 8 ]

[ Next Thread | Previous Thread | Next Message | Previous Message ]

Date Posted: 22:09:18 04/13/02 Sat
Author: Mike Martz
Subject: 3.3 volt regulator help

I have my CC ready for a 6400/200 motherboard. I am currently using an LC580 logic-board in it. Can some tell me if I can buy the 3.3volt regulator circuit pre-assembled? and ready to wire in? also how much current does the 3.3v circuit draw without any PCI cards present?
I have a power supply from a Pacard bell 486 that I think I can fit in the case, I was going to use it for the hard drive and would like to know if I can provide the 3.3volts with this power supply. I'd also like to know if anyone has replaced their floppy with an IDE ls-120 drive, will the logic-board support both a master & slave device? help me get this crash prone PC off of my desk PLEASE!

[ Next Thread | Previous Thread | Next Message | Previous Message ]

Replies:

[ VoyUser Login ] Not required to post.
Post a public reply to this message | Go post a new public message
 Note: This forum is moderated -- new posts are not visible until approved.
* Notice: Posting problems? [ Click here ]
 * HTML allowed in marked fields.
Message subject (required):

Name (required):

  Expression (Optional mood/title along with your name) Examples: (happy, sad, The Joyful, etc.) help)

  E-mail address (required):

* Type your message here:


Note: This forum is moderated -- new posts are not visible until approved.

Notice: Copies of your message may remain on this and other systems on internet. Please be respectful.

Forum timezone: GMT-8
VF Version: 2.94, ConfDB:
Before posting please read our privacy policy.
VoyForums(tm) is a Free Service from Voyager Info-Systems.
Copyright © 1998-2008 Voyager Info-Systems. All Rights Reserved.