VoyForums
[ Show ]
Support VoyForums
[ Shrink ]
VoyForums Announcement: Programming and providing support for this service has been a labor of love since 1997. We are one of the few services online who values our users' privacy, and have never sold your information. We have even fought hard to defend your privacy in legal cases; however, we've done it with almost no financial support -- paying out of pocket to continue providing the service. Due to the issues imposed on us by advertisers, we also stopped hosting most ads on the forums many years ago. We hope you appreciate our efforts.

Show your support by donating any amount. (Note: We are still technically a for-profit company, so your contribution is not tax-deductible.) PayPal Acct: Feedback:

Donate to VoyForums (PayPal):

[ Login ] [ Contact Forum Admin ] [ Main index ] [ Post a new message ] [ Search | Check update time | Archives: [1], 2, 3, 4 ]
Subject: lowering rear or irs type3 square problem


Author:
the rev bagette
 		[ Next Thread | Previous Thread | Next Message | Previous Message ]
Date Posted: 15:36:56 06/22/04 Tue
Author Host/IP: 195.92.168.164
 i have lowered the rear of my square, by one inner spline.
this has dropped it around 4 inches
i would like to go a tad lower, but i cant get the springplate free of the outer splines, its had wd40 on / blowtorch etc wont budge, how much will it drop if i do another inner spline one click, if its another 4 inches then its a non starter, should i persevere with getting the springplate off the outer splines.........suggestions anyone ?
[ Next Thread | Previous Thread | Next Message | Previous Message ]

Replies:
Subject Author Date
Re: lowering rear or irs type3 square problemthebackdoctor
(195.93.33.13)		13:17:14 06/24/04 Thu

[ Contact Forum Admin ]

Forum timezone: GMT-8
VF Version: 3.00b, ConfDB:
Before posting please read our privacy policy.
VoyForums(tm) is a Free Service from Voyager Info-Systems.
Copyright © 1998-2019 Voyager Info-Systems. All Rights Reserved.