Re: Engine Tinware -- T3D Chat

[ Show ]

Support VoyForums

[ Shrink ]

VoyForums Announcement: Programming and providing support for this service has been a labor of love since 1997. We are one of the few services online who values our users' privacy, and have never sold your information. We have even fought hard to defend your privacy in legal cases; however, we've done it with almost no financial support -- paying out of pocket to continue providing the service. Due to the issues imposed on us by advertisers, we also stopped hosting most ads on the forums many years ago. We hope you appreciate our efforts.

Show your support by donating any amount. (Note: We are still technically a for-profit company, so your contribution is not tax-deductible.) PayPal Acct: Feedback:

Donate to VoyForums (PayPal):

[ Login ] [ Contact Forum Admin ] [ Main index ] [ Post a new message ] [ Search | Check update time | Archives: [1], 2, 3, 4 ]

Subject: Re: Engine Tinware

Author:
miketyp3

[ Next Thread | Previous Thread | Next Message | Previous Message ]

Date Posted: 05:18:10 09/07/04 Tue
Author Host/IP: 62.232.13.10
In reply to: Clem 's message, "Engine Tinware" on 17:00:31 08/20/04 Fri

You should be able to get away without the puller. Just make sure you prise the pulley off nice and even and don't put too much load on the cast housing, as it's quite brittle.
All the gaskets you'll need should be in the T1 gasket pack.

Hope that helps.

Mike.

>Taking a break from body work, Im stripping the engine
>to clean and paint etc. Never having done a T3 lump
>before, Im being cautious. To remove the main front
>casing the front pulley wheel need removing ... the
>manual shows a puller - is this required? or can it be
>prised off?
>Also gaskets? Are these Type 1 engine interchangable,
>if not are they readily available?
>Cheers.

[ Next Thread | Previous Thread | Next Message | Previous Message ]

Replies:

Subject	Author	Date
Re: Engine Tinware	Clem (62.255.0.4)	12:59:07 09/07/04 Tue