Subject: Access to upper flourescent lights in bedroom of 1990 40'pusher??
Author: John Harvat
[ Next Thread |
Previous Thread |
Next Message |
Previous Message
] Date Posted:01/ 26/ 10, 7:50am
I need to replace the ballasts in the upper lights in the bedroom. What is the best way to remove the valence board? I see hinged brackets both above and below the horizontal board that supports both the upper and lower lights. Can I remove the top plate horizontal screws and then allow the valence to swing down or do I have remove both the upper and lower ones. I have two left hands so I need step by step handholding on this.
Date Posted:01/ 26/ 10, 10:02am
Do not know your model and year , but there may be screws under the white tape covering on the bottom of the valance near the drape track
Date Posted:01/ 27/ 10, 5:50pm
The model is 1990WLWB. I looked at the drapery track an it appears that the track will have to be removed to see what is above it. I don't think it will get me to the outer valence plate that I need to remove. The Valence board is a good 6 inches up and 6 inches out from where the drapes are mounted. Thanks for the suggestion.
Date Posted:02/ 21/ 10, 10:04am
It has been a long time but I removed the valances in a '90 PT40 WB and, as I recall, there were angle brackets inside that required removal with an angle screwdriver. Have you checked with a hand mirror?
