[
Next Thread |
Previous Thread |
Next Message |
Previous Message
]
Date Posted:26/01/07 0:03:43 In reply to:
Ken Snead
's message, "Trapper 28" on 25/01/07 18:06:19
You need a puller, I made my own using studding and pipe and washers, but that design required shaft removal.
The local marine engineer has a split design that means you only need to remove the prop.
The same beast is used to push the new one back in.
If the P bracket is the same design as used on the 500/501 there is a small socket set screw that acts as a lock, you need to remove this first.
On our 501, the P Bracket was a non standard size and we had to have a few thou taken off the outside of the cutlass bearing housing to get it to fit.
[
Next Thread |
Previous Thread |
Next Message |
Previous Message
]